Ci-dessous, les différences entre deux révisions de la page.
Les deux révisions précédentes Révision précédente Prochaine révision | Révision précédente Dernière révision Les deux révisions suivantes | ||
materiel:ad9850:accueil [2015/02/18 19:09] resonance |
materiel:ad9850:accueil [2015/02/18 21:46] resonance [Avec Arduino] |
||
---|---|---|---|
Ligne 3: | Ligne 3: | ||
Générateur de signaux sinusoïdaux ou carré. | Générateur de signaux sinusoïdaux ou carré. | ||
+ | {{youtube> | ||
===== Datasheet ===== | ===== Datasheet ===== | ||
* {{: | * {{: | ||
- | {{:materiel:ad9850: | + | * 2 sine wave and 2 square wave output (mais tous avec la même fréquence !) |
- | + | * AD9850: 0-40MHz | |
+ | * After the 20-30MHz frequency harmonics increases, the waveform will be less and less clean | ||
+ | * Square Wave: 0-1MHz | ||
+ | * Low-pass filter with 70MHz, so the waveform better than SN | ||
+ | * Parallel and serial data input can be selected via a jumper | ||
+ | * DA produced the benchmark pin (PIN12) leads for easy adjustment to do the magnitude of the output waveform Application | ||
+ | * Comparator reference input voltage generated by the variable resistor, the resistor can be adjusted duty cycle square wave of different | ||
+ | * Active AD9850 125MHz crystal oscillator modules | ||
===== Avec Arduino ===== | ===== Avec Arduino ===== | ||
Ligne 15: | Ligne 22: | ||
* http:// | * http:// | ||
* http:// | * http:// | ||
+ | * http:// | ||
+ | * http:// | ||
+ | * http:// | ||
+ | |||
+ | |||
+ | ==== Connection ==== | ||
+ | Il suffit de 6 fils. | ||
+ | |||
+ | | **ARDUINO** | **AD9850** | | ||
+ | | 5V | VCC | | ||
+ | | GND | GND | | ||
+ | | 8 | W_CLK | | ||
+ | | 9 | FQ_UD | | ||
+ | | 10 | DATA | | ||
+ | | 11 | RESET | | ||
+ | {{: | ||
==== Code Arduino pour deux modules ==== | ==== Code Arduino pour deux modules ==== | ||
Ligne 139: | Ligne 162: | ||
===== Modulation ===== | ===== Modulation ===== | ||
- | Deux signaux modulés par une porte ET : | + | Deux signaux modulés par une porte ET : \\ |
- | {{: | + | {{: |
- | Le schéma de la porte ET avec deux diodes et une résistance (merci Patrick!) | + | Le schéma de la porte ET avec deux diodes et une résistance (merci Patrick!)\\ |
{{: | {{: | ||
+ | |||
+ | ===== Signal carré ===== | ||
+ | Il faut modifier le "duty cycle" du signal carré avec le potentiomètre. | ||
+ | |||
+ | {{: | ||
+ |